|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-22-2009, 01:43 PM
|
#1 |
|
Registered User
Join Date: May 2005
Location: Missoula, MT
Posts: 273
|
Need help...again. Frame question
Im gunna go work on my the ole 67 today but before I head out there I want to swing in and get some sheet metal and some metal to make the rear most xmember since mine was scraped. I hate that I cant just go out and take the measurement for myself since the truck is 20 miles away. I plan on getting about 34 inches long so I have some room to trim to fit but I need to know how tall the frame rail is from the inside edge to inside edge where the rear xmember rivet hole is. Anybody? I searched and searched but just was having no luck. Thanks a million.
Todd project "FED UP"
__________________
- 1967 Chevy C10 shortbox - 1984 Chevy K10 "Mater"- SWB 305 manual, retired sheriffs truck, Current Frame Off Project - 1986 Chevy K10 LWB 350/350 Daily Driver/project |
|
|
| Bookmarks |
|
|
Threaded Mode