No bites in the FS section - price question

[lks dcvn]

I would gather that my price is too high for this truck...so I am looking to see what I should ask for it...

Here are the details:

Build thread can be found here:
http://67-72chevytrucks.com/vboard/s...light=lks+dcvn

1970 C-10 Long Wheel Base Pickup Truck - Clear Ohio Title in my name
350 engine - needs a smaller carb installed on it - runs too rich right now and dies out at times
TH400 Trans - rebuilt less than 500 miles since rebuild
6 lug [6x5.5 bolt pattern] 4 wheel drum brakes - completely rebuilt - last year
Front Suspension - items that needed replaced were replaced [A-arm bushings, had an alignment done as well]
New [White] Single Stage Paint - I did the body work and paint in my driveway - it isn't perfect, but for a daily driver it will be fine.
New 2.5" Corvette Ram Horn Manifolds into 2.5" Exhaust with 40 series mufflers
Rebuilt Dash Cluster - white accents color matched to truck
All new lenses for turn signals, brakes, etc.
New Exterior Handles
New Seat Cover
New Black Carpet
New Radio Antenna
New Heater Controls
New Heater Cables - replaced old and used graphite on new ones so they slide easy now

Most of the parts on the truck are new, rebuilt, aftermarket or upgraded in some way.

The truck is in locked storage until April so I can't get any pix right now.

I have almost every receipt and a spreadsheet of all the parts and their prices to go with the truck.

Things it needs to be completely done:

1. Smaller Carb Installed and Dialed in - I have a Quadrajet that needs rebuilt that can go with it. It currently has a Double Pumper 750 on it.
2. Driver Side Door adjusted a bit - it does close and latch but the new weatherstrip that was installed doesn't allow it to shut flush yet.
3. Interior Door Panels and 6x9 speakers installed [I have the door panels - just need to get the 6x9's installed and then put on the door panels - 30 mins work]
4. Heater wiring needs checked - Blower Motor is good [tested it], but it does not kick on with dash switch - I plan to check it out when it gets out of storage
5. Needs to have the interior light pins on the a pillar adjusted to work correctly

The powder coated 6 lug rally wheels and the tires will be used on another project so they do not come with the truck at this time.

I was going to resolve these last few issues when I get it out of storage in April and then put it up for sale, but I figured I would post it up now to see if there was any interest.

Rust - there is some minimal cancerous rust in the rear driver side cab mount - it appears to be isolated there...

Thanks for the help everybody. I built if for my Dad - but it looks like he won't be needing it.