Three on the help - The 1947 - Present Chevrolet & GMC Truck Message Board Network

cparman · 03-04-2010, 07:11 PM

Well this old man stepped on his tongue today. I have a 69 c-10 in my shop, and it had a cheapo floor shifter in it that was worn out. I told the owner I had everything he needed to make it a TOT. Well, I almost had everything. My 69 was a TOT, but mine is a v-8, his is a six. The frame engine mounts on mine are in the front two holes, and his are in the rear two holes. I have what I think is the correct rods that run from the column to the trans, but IF all of you 6 cyl guys would help a brother out with a picture or two My morning might go better

I would also be much appreciative of this

Chip

03-04-2010, 07:11 PM	#1
cparman sharp as a marble Join Date: Jan 2007 Location: atlantic beach,florida Posts: 1,082	Three on the help Well this old man stepped on his tongue today. I have a 69 c-10 in my shop, and it had a cheapo floor shifter in it that was worn out. I told the owner I had everything he needed to make it a TOT. Well, I almost had everything. My 69 was a TOT, but mine is a v-8, his is a six. The frame engine mounts on mine are in the front two holes, and his are in the rear two holes. I have what I think is the correct rods that run from the column to the trans, but IF all of you 6 cyl guys would help a brother out with a picture or two My morning might go better I would also be much appreciative of this Chip



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.