Interior Carpet question. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jorgensensc · 03-25-2010, 12:58 PM

So I went to lay out the carpet for the burb yesterday. The pieces are ACC and appear to fit well except... Where the rear cargo bed is raised above the regular floor pan. The carpet ends on both pieces and doesn't go up the riser between the two floor pieces. I called ACC and they were very confused. They finally told me that there was a metal piece that went on that riser.Is that true? I have never seen a metal piece on the riser (step) up into the cargo area from the front side. if its true, where can I get one? Thanks!
Shawn

03-25-2010, 12:58 PM	#1
jorgensensc Registered User Join Date: Jul 2003 Location: Cypress, Tx Posts: 4,005	Interior Carpet question. So I went to lay out the carpet for the burb yesterday. The pieces are ACC and appear to fit well except... Where the rear cargo bed is raised above the regular floor pan. The carpet ends on both pieces and doesn't go up the riser between the two floor pieces. I called ACC and they were very confused. They finally told me that there was a metal piece that went on that riser.Is that true? I have never seen a metal piece on the riser (step) up into the cargo area from the front side. if its true, where can I get one? Thanks! Shawn __________________ 1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.