PROJECT "Father/Son" C-20 Rolling Chassis Build

[rcrahn]

Update on the 6.0/4L80E

Ordered xmember from POL. Nice looking part....
However, the ends would not fit between frame rails. Real tight and I wasn't about to force anything. Soooooo, cut off top section to do fit up.

Next raised trans up to correct 2 degree angle and.............

Yes, 4L80E hits the cab floor (with short hump). This sucka is big...




So after some cursing decision made to next cut out/raise section of floor. Yes, I had that annoyed look going again. Also, need to fabricate another X member. Although the POL xmember is nice it will need about a 1" spacer and that's simply too much.

Custom x member will likely start with 3" tube.....

Oh well......