|
05-26-2003, 10:32 PM
|
#1 |
|
Pronounced "Pew-al-up"
Join Date: Oct 2002
Location: Puyallup, Washington
Posts: 845
|
Tach install
I am installing an aftermarket tach in my truck, but I am finding
that the tach is too deep for the bezel, and I am going to have to remove part of the printed circuit board. My question is, has anyone tried to jump out the circuit board by soldering in jumper wires that will allow me to cut away part of the printed circuit board to make room for the new tach ?? Will solder adhere to the circuit board? This tach looks sweet with my white face gauges, and I really want to make it work. Any input is greatly appreciated!! Remember our soldiers!!  Thanks, Dan
__________________
Classic GM Trucks of Washington Club Member 1970 FS chevy,350/350, Edelbrock cam and intake. Holley 650 carb,HEI,AT,Tangier Orange, 18's, Power Locks, Truck Photos |
|
|
| Bookmarks |
|
|
Threaded Mode