Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
07-20-2010, 10:41 AM | #2 |
Next project: 1970 K10
Join Date: Feb 2004
Location: Fort Collins, Colo 80524
Posts: 6,685
|
Re: Is it necessary to run rubber fuel line from the cab to the frame?
Sure you could. But I would use a short section (6" - 8") of rubber or braided stainless between the steel line and the fuel rail. I would think there needs to be a little something there to take up any twist and vibration, like an OEM setup is.
I don't remember if you are using the stock in-cab tank, and something in the rear. Does the in-cab tank have a threaded fitting on the fuel line into the sending unit?
__________________
Bob 1970 Chevy K10 LWB "Goldie" 350/TH350 next project!! 1981 Chevy C10 LWB 355/TH350 - My son's truck LS SWAP FORUM! Tons of LS swap info here! PLEASE CLICK HERE TO SUPPORT THE GREATEST BOARD ON THE NET! CLICK HERE FOR THE FAQ INDEX by KRUE Last edited by glock35ipsc; 07-20-2010 at 10:42 AM. |
Bookmarks |
|
|