VA Passenger side Blazer/Jimmy original door no rust - The 1947 - Present Chevrolet & GMC Truck Message Board Network

VA72C10 · 08-03-2010, 08:07 AM

LOWERED PRICE

I have a door that came off my 71 blazer. The bottom corner had some minor rust on the inside that was cut out and new metal welded in. Some hairline cracks were starting to develop around the upper hinge so that area was welded properly. Bottom of door is perfect. No other dents/dings I see (other than repaired areas in picture). The only other area to note is where the factory hinge brace mounts. It was removed to go on the repop door the PO used so it will need a new one.

Asking 225 FIRM plus shipping. Repops run more than this and trust me....they take a lot of work to make fit correctly. Again, this is an original blazer door....not a cut down truck door.

clean door bottom

inside

08-03-2010, 08:07 AM	#1
VA72C10 VA72C10 Join Date: Mar 2008 Location: Midlothian, VA Posts: 25,267	Passenger side Blazer/Jimmy original door no rust LOWERED PRICE I have a door that came off my 71 blazer. The bottom corner had some minor rust on the inside that was cut out and new metal welded in. Some hairline cracks were starting to develop around the upper hinge so that area was welded properly. Bottom of door is perfect. No other dents/dings I see (other than repaired areas in picture). The only other area to note is where the factory hinge brace mounts. It was removed to go on the repop door the PO used so it will need a new one. Asking 225 FIRM plus shipping. Repops run more than this and trust me....they take a lot of work to make fit correctly. Again, this is an original blazer door....not a cut down truck door. clean door bottom inside __________________ Looking for a 67-72 swb or blazer project in or around VA. Last edited by VA72C10; 12-14-2010 at 11:38 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.