Dana 44 help.

[swamp rat]

Hi all, I have a dana 44 open knuckle under my 3/4 ton and am debating if i should do the steering knuckles myself or have it done. Need to know what kind of special tools i might need but most importantly i need some good step by step reference material so was hoping someone out there can steer me in the right direction.

I find stuff for Fords and jeeps on line but wanna be sure i have the correct reference material to read up on before i decide if i start the job or hire it done.

I have done wheel bearings on trailers or front of 2wd cars ect, and have installed warn hubs and have a little training on a few heavy equipment pumpkins about 30 years ago but never have i ventured into steering knuckels and hubs ect from a front axle. I'm sure i have the ability but don't know if i have all the right tools (specialty) or even where would be a good place to find the correct bearings and seals. Thanks