|
08-15-2010, 04:51 PM
|
#1 |
|
Registered User
 Join Date: Feb 2009
Location: Alpine Ca,
Posts: 123
|
1963 Seat
I am putting a 63 seat in my 62 and have taken it apart and am powder coating the two halves. When I took the seat back off I noticed that it had small plate on the corners of the seat half that I believe is to have an adjustment for the angle of the seat back.
It is only on one side which may mean it was broken off the other side and it would seem you would want them the same on each side. I need to fix the crack weld on one side and make a new one for the other side. Does anyone have a picture of what it is supposed to look like and what the adjustment bolt or stud looks like. |
|
|
| Bookmarks |
|
|
Threaded Mode