Project: Custom 71 4x4 hotrod - The 1947 - Present Chevrolet & GMC Truck Message Board Network

silver7 · 08-18-2010, 09:17 PM

Received my last couple of powder coated parts back from 'Unique Coatings' today so I was able to get my front springs installed on the frame. Looks good.

Also received my dana 44 spanner wrench today which I'll need to get my steering knuckle with new ball joints fastened to the dana 44 yoke. Let me tell you - it was a tough little SOG to find. I will use it to remove those 'plugs' aka yoke upper ball stud adjusting sleeve so I can install new ones.

08-18-2010, 09:17 PM	#11
silver7 Registered User Join Date: Jul 2009 Location: High Point, NC Posts: 613	Re: Project: Custom 71 4x4 hotrod Received my last couple of powder coated parts back from 'Unique Coatings' today so I was able to get my front springs installed on the frame. Looks good. Also received my dana 44 spanner wrench today which I'll need to get my steering knuckle with new ball joints fastened to the dana 44 yoke. Let me tell you - it was a tough little SOG to find. I will use it to remove those 'plugs' aka yoke upper ball stud adjusting sleeve so I can install new ones. Attached Images __________________ Shawn 1971 C10 4x4 Last edited by silver7; 08-21-2010 at 05:36 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.