FS: Short Step Bed Sides and Fender - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**1971Stepside** · 06-09-2003, 06:04 PM

I have three bedsides for sale. All of them are in better than average shape, but each would take body work to make them show quality (dings and etc.). I have two drivers side bed sides and one passenger side. No rust on any of them. Pics available. Please only respond if you are able and willing to purchase. I am asking $75 per bed side. Would rather not ship, but if you want to pay the shipping I guess it could be done.

I also have a passenger step fender that is rust free. It is dented at the very bottom on the back side, but could be hammer and dollied out pretty easily. I would take $75 for the fender. I also have a very clean step for the passenger side. $30

I have a drivers side fender that has no rust, but has some filler in the front of it (no cut out) to cover a rippled up dent. It is also slightly tweaked at the front corner, but could be easily pulled. I may try that before shipping it out. Again, probably a daily driver type fender. $35

Shipping is up to you, but I would rather you come and get the pieces.

Post interested messages here or PM me your email for pics. Thanks.

06-09-2003, 06:04 PM	#1
1971Stepside Almost Satisfied Join Date: Mar 2002 Location: Springfield, MO Posts: 2,932	FS: Short Step Bed Sides and Fender I have three bedsides for sale. All of them are in better than average shape, but each would take body work to make them show quality (dings and etc.). I have two drivers side bed sides and one passenger side. No rust on any of them. Pics available. Please only respond if you are able and willing to purchase. I am asking $75 per bed side. Would rather not ship, but if you want to pay the shipping I guess it could be done. I also have a passenger step fender that is rust free. It is dented at the very bottom on the back side, but could be hammer and dollied out pretty easily. I would take $75 for the fender. I also have a very clean step for the passenger side. $30 I have a drivers side fender that has no rust, but has some filler in the front of it (no cut out) to cover a rippled up dent. It is also slightly tweaked at the front corner, but could be easily pulled. I may try that before shipping it out. Again, probably a daily driver type fender. $35 Shipping is up to you, but I would rather you come and get the pieces. Post interested messages here or PM me your email for pics. Thanks. __________________ 1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far."



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.