48 GMC 1-1/2 ton to 55 1st series 1/2 ton door interchange question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**WIDESIDE72** · 09-25-2010, 11:27 AM

Is it possible to install 1948 doors on a 1955 1st series? I have a 55 Chevy 1st series 1/2 ton, and the doors are so-so rust wise, and need new glass. My dad has a 1948 GMC 1-1/2 ton flat bed with pretty nice doors. I was thinking that a lot of the 67-72 guys pay a lot of $$$ to go to one piece door glass, I would see if I could do it on the cheap. I am putting the truck on an S10 frame, so originality is not an issue. I figure since the truck is going to have A/C and I probably wouldn't use the wing windows much, the one piece windows would help eliminate a possible source of wind noise.

09-25-2010, 11:27 AM	#1
WIDESIDE72 Senior Member Join Date: Aug 2008 Location: Cedar Park, Texas Posts: 7,500	48 GMC 1-1/2 ton to 55 1st series 1/2 ton door interchange question Is it possible to install 1948 doors on a 1955 1st series? I have a 55 Chevy 1st series 1/2 ton, and the doors are so-so rust wise, and need new glass. My dad has a 1948 GMC 1-1/2 ton flat bed with pretty nice doors. I was thinking that a lot of the 67-72 guys pay a lot of $$$ to go to one piece door glass, I would see if I could do it on the cheap. I am putting the truck on an S10 frame, so originality is not an issue. I figure since the truck is going to have A/C and I probably wouldn't use the wing windows much, the one piece windows would help eliminate a possible source of wind noise. Last edited by WIDESIDE72; 09-25-2010 at 02:10 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.