|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-23-2010, 12:55 PM
|
#1 |
|
Registered User
Join Date: Sep 2009
Location: Syracuse NY
Posts: 684
|
Annoying Snag in Tranny Installation
I have an 86 K20 I'm putting together and for some reason when I attempt to install the TH400 on the back of my 350 engine the tranny comes within a quarter inch of making contact with the engine block and just stops. What gives? I checked and cleaned the dowel holes, tried turning the engine just a hair, but I can't get the stupid tranny on!
 There doesn't appear to be a guide pin on the end of the tranny shaft. Can you guys think of something I'm missing? Thanks!
__________________
Project #1 "Pops"--1980 Chevrolet Scottsdale C10 3rd Generation in the same original owner family. GOAL: Restore to "almost" original. View Project Pops HERE Project #2 "Cletus"--1986 Chevy K20 4.10 Gear Ratio GOAL: Restore into a heavy duty work/plow rig View Project Cletus HERE - SOLD DD--2008 Duramax CCSB |
|
|
| Bookmarks |
|
|
Threaded Mode