Project 59 Apache "1st Build"

[Tri5Nerd]

Originally Posted by Fat Mike

I still have to cut a hole in the boxed side and put a piece of pipe through it to sleeve the hole for more support for that bolt. If you look very close there is a small gap if ther was any water and I was going to put 3 small hole as bleeders in the bottom.

Does anyone know how much it might cost to cut down one side of that tank and have it rewelded?

Mike, Be very careful about cutting and rewelding a used tank, there can be a fire if you dont completely get all the gas and fumes out of the tank. Why don't you look into a mustang and Chevy Van tank. I see them new online for a little over $100.