|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-18-2010, 12:35 PM
|
#1 |
|
Registered User
 
Join Date: Oct 2006
Location: San Jose NOR*CAL
Posts: 3,080
|
1960 wheel bearing question
After doing my master cylinder swap , and having to adjust the front brakes I decided that I was going to replace a broken front stud and,repack the front wheel bearings. (They are the ball bearing type)
But I cant seem to get them out, and I cant get the front hub off.So whats the trick? What am I over looking? In the long run I am going to install my front disc brake spindles, but that is down the road a bit, so I dont want to buy new bearings ,or a used hub. Thanks in advance
__________________
1960 Apache long bed fleet L6 250 Clifford intake 2 bbl carb. Langdon cast headers with dual exhaust and bellflower tips. T-5 5 speed, power steering and power disc brakes. "Over, Around or through it... " Last edited by slepysal; 11-18-2010 at 12:35 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode