The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 11-19-2010, 05:53 PM   #1
dyrt
Registered User
 
Join Date: Jul 2007
Location: Yardville, NJ
Posts: 144
Changing driveshaft bearing type, replacing driveshaft

Howdy people,

My 69 c10 longbed originally came equipped with an inline 6, 3 speed, and the smaller driveshaft bearing(bolts are front to back, not side to side.) This means it also came with the small diameter driveshaft. I am installing a 6.0 and 4l60e so i want to change to the larger style bearing and larger diameter driveshaft. Doesy anyone know of a good donor truck for the larger driveshaft? Also, i need a bracket for the heavier duty bearing. I have seen one that hangs from the top of the trailing arm crossmember(so the bearing hangs down from it on the back side) and one that bolts to the bottom(so the bearing is essentially inside the crossmember) while looking at pictures in threads all over the forum. Are there two different brackets for a reason or did someone just bolt a later bracket into a crossmember and use it? Can anyone with any experience in this swap chime in?


Mike
dyrt is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:11 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com