GEN III C10 Full Air ride build

[breeze85cten]

I finally had enough time to finish the harness and route it to all the sensors and wire loom it! The engine harness is ready and just fired her up today for the first time!!! Sounds awesome with the big cam. Of course the video doesnt do it justice. At first I couldnt get oil pressure for the life of me so I went thought it might be the pick up tube being pinched but changed it and it wasnt it then went to my last resort which was change the oil pump but after I did that it still was the same no pressure! This whole time I was turning the engine over with the starter and no spark plugs to build pressure but it wasnt enought so I ended up pooring oil down the oil sensor hole and then went to actually start it and it had oil pressure within 3 seconds!! Thank god. So all I had to do was prime it through the oils sensor hole!! Hope you guys like it.