|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
02-26-2011, 04:32 PM
|
#1 |
|
Registered User
Join Date: Nov 2010
Location: Grand Terrace, Ca.
Posts: 1,607
|
Pinion angle\2 piece driveline question
I'm getting ready to set the pinion angel on my coil spring 69 1\2 ton long bed. I have information that you set the pinion angle just as you would if you were working on a single piece driveline (pinion 3* above horizontal, crank\out put shaft 3* below horizontal)...does anyone know, is this true? Location of the carrier bearing doesn't come into play?
|
|
|
| Bookmarks |
|
|
Threaded Mode