Shrunken66Stroker's build thread.

[65Pickup]

Originally Posted by shrunken66stroker

They're Dynatech MuscleMaxx headers with 1 7/8 primaries and 3" collecters. I meant to post that pic in another thread so I can get a measurement and see if they will hang down past the frame rails. I've seen them on different trucks and they seem to hang about 2-3 inches below the frame. I'm not sure if they'll work but there aren't many long tube alternatives for a 66 C-10 with an LS swap.

Yeah I hear ya, I've been looking for 1 3/4" primaries for a 1st gen SBC, suppose to use headers for 68 and newer trucks, frames are the same, is the advise I was given. With an LS swap good luck, I'll check out Dynatech.