|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-08-2011, 11:26 PM
|
#1 |
|
Registered User
Join Date: May 2004
Location: Chandler, AZ
Posts: 519
|
Polyurethane Bushing Question
I'm replacing my rear control arm bushings with polyurethane bushings. The photo below shows the bushings but they came two slide washers that cap over the skinny end.
I've got the bushing in but noticed that even with the bushing pressed all the way in, it's too wide to squeeze back into the mount with the slide washer on. Should I try triming down the slide washers or just not use them? Thanks.
__________________
 69 C-10 LWB, 350, 700r4, 3.73 posi-traction, front disc brakes. Built for the desert- She can take the heat! Vivat Rex Chevus! 
Last edited by Zonaman; 03-08-2011 at 11:29 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode