Drop Spindles and Tie Rod Length, 69 C10

[69BB396]

Installed the CPP front 2.5drop spindles w/discs that allow using stock tie rods. Installed new PS gear and pitman, and found centre by rotating (2.5 turns side to side therefore 1.25 is center). Installed center link and idler, then assembled tie rods.
Problem: with tie rods at minimum length, I can see they are a bit too long and both rotors are a bit outward at the front. I haven't used a string yet to
get a better reading, but I think I need about an Inch or so on each side.

What is the best fix? Is it safe to trim the tie rod lengths to get fitment?

I checked the new parts with the old, all sizes seemed correct.
My center link is original.

Ron