Structures 65 Chevy C10

[structures]

Still patchin'

















I went a little different on the left side. I cut the kick panel out high because it was so hard to smooth the welds from cutting it low where the piece has the joggles stamped in. I also cut it out so that I could drill out the spot welds and slide it out from the outer pillar wall and inner rocker wall.
When I removed the floor panel the rust was minimal. I wire brushed and vacuumed the best I could, then used my under coating gun to por-15 everything.




I went with the universal pan on the left side. I wish I would have paid the extra money and got the OEM stamped panel. The panel was really off so I had to cut my patch in two to get it to fit.