one piece or two piece driveshaft - The 1947 - Present Chevrolet & GMC Truck Message Board Network

onetoncrewcab · 07-15-2003, 07:02 AM

OK. I know this has been hashed on the board a few times, but I can't remember what the advice has been regarding going with a one piece or two piece driveshaft. And with seach down....well here is the question again.

I'm putting a 700R4 trans in the 70 Chev pickup. It has a two piece driveshaft now. Should I have that one modified or switch it over to a one piece?

I have the driveshaft out of the 85 Sub that I used for a engine/trans donor. Is this driveshaft going to be long enough to use for a start? I'm guessing it is going to be too short.

Thanks for the advice so far on this project!
Mike

07-15-2003, 07:02 AM	#1
onetoncrewcab One of my kids. Cute eh? Join Date: Oct 2001 Location: Mitchell, SD Posts: 1,286	one piece or two piece driveshaft OK. I know this has been hashed on the board a few times, but I can't remember what the advice has been regarding going with a one piece or two piece driveshaft. And with seach down....well here is the question again. I'm putting a 700R4 trans in the 70 Chev pickup. It has a two piece driveshaft now. Should I have that one modified or switch it over to a one piece? I have the driveshaft out of the 85 Sub that I used for a engine/trans donor. Is this driveshaft going to be long enough to use for a start? I'm guessing it is going to be too short. Thanks for the advice so far on this project! Mike __________________ If a kid asks where rain comes from, I think a cute thing to tell him is “God is crying.” And if he asks why God is crying, another cute thing to tell him is “Probably because of something you did. John 3:16 2006 Chevy HHR 2000 Dodge Durango 1985 Jeep CJ-7 1970 Chevy Pickup



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.