1964-66 Suburban Front and Rear Seat, trim, etc

[JimmyFloyd]

Picking up some parts off this suburban and was wondering what some parts are worth, and what else should I grab off it.

- Front split 70/30 seat. Frames are in great shape. Have both sliders for the driver's side. Passenger side I have all 4 clips for the seat and the frame is great, just some surface rust. Foam is good on the passenger side and cover is 90-95% complete, but has some tears. Driver's seat has bottom and back frames, but fabric is bad. Bottom is missing a couple springs in the seat, but the outer frames and wood cross braces are there. No bolts for brackets to frame, or brackets to floor though.






- Rear seat. Frame is in good shape. Back rest is good, has some rips, foam is ok on it. Bottom frame is there, but it is pretty messed up. There are 2-3 big dents in it, and several of the smaller springs are broken and need to be replaced. All the larger springs appear to be there. No foam or fabric on it. Probably best for parts, but could be made to work again. Seems to be a full width seat. No arm rests (if they had them) or mounting hardware to mount to the floor.




- Ash tray

- Barn door slider beackets. good shape

- Upper and side bolt covers for barn doors. I believe these cover up the holes for the gate mounts. Might be the other way around.

- Rear door latch loop with 2 shims.


- Upper window trim. this is the trim above and below the windows. Includes top piece, bottom piece, rear piece and door pieces. From what I can see, all are dull, but good shape. Driver's side upper has a dent in it above the center of the rear windows. Could not see driver's side one to check condition. Need to know how to properly remove this






- Rear solid fixed window. Both are in good shape and 1 piece. Rubber is dry rotted.

- Middle sliding windows. No latch/locks. Glass is good, rubber is bad

- Inner window trim/molding/holder. The pieces that go inside to hold the windows in. All appear to be in good shape.




Not sure what these are worth. This truck is in a local junkyard, and I will be removing and have in my possession any parts I plan to sell prior to being listed, but just want to gauge if it is worth my time to do it. I'd hate to see good parts get crushed.