|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-10-2011, 06:36 PM
|
#5 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
Re: Turbo 400 bolt in yoke ?
You do have to pull the trans completely down to swap the shaft, but there is another option. You can use the bolt on yolk, & opt to build the drive shaft with a slipyolk in the middle(3/4 tons are set up this way). crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
| Bookmarks |
|
|
Threaded Mode