got the 400 installed and running!! (lots of pics and couple videos!)

[badblu97]

So Ive been working on the 5 lug swap, power brakes, power steering, th350 install, and I had a catastrophic failure of the 327, so in went the 400 (406, its bored .30 over) I had laying around. I still have a little exhaust leak, need to install the power steering pump, and fine tune her. This engine was rebuilt in 1993, sat for around 13 years, installed in another c10, ran for around a 1000 miles, pulled out, and its been sitting for 4 years, in my shop. We didn't clean the carb, change a plug, or wire, all we did was change the oil pan gasket, rear main seal, new oil and filter. The engine is bored .30 over, roller rockers, cam, intake and carb are all matched from Edelbrock. I am unsure of the specs of the cam and all, because my Dad rebuilt it so long ago, he cant remember! Its a STRONG motor, and I cant wait to drive her......