![]() |
![]() |
#9 |
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,938
|
Re: Project: Recycle
Pass side from manifold to TA x-member all tacked together & installed. I'll drop the starter tonight & make sure it's good to weld.
The drivers side got tacked together as well. I made a small 'spool' piece to get the best alignment so I still need to do some finish grinding for the best clearance. I should be able to get the drivers side all tacked together (to the TA x-member) by tomorrow. Then I'll start on the cross-over pipe. On a bad note.... I unfortunately confirmed the diagnosis on the dually's BBC when I checked the oil again this morning. It definitely has a blown head gasket.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. Last edited by SCOTI; 06-16-2011 at 03:24 PM. |
![]() |
![]() |
Bookmarks |
|
|