|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-17-2011, 11:26 AM
|
#1 |
|
Registered User
Join Date: Feb 2011
Location: belpre ohio
Posts: 78
|
Upper control arm spacers
I need a little advice.. I'm curently in the procces of lowering my 81 C10 and wanted to use the factory control arms to save a few bucks. As low as i'm going this causes problems. I cut off the original upper control arm bolts and welded in 1/2 grade 8 bolts that are about 2inchs longer so i have more adjustment.. I didnt want to use shims to fill in the gaps so I made these.. what do you guys think.Will this work or should i just start over.. Also if this info helps on the rear I did an axle flip and 3 inch drop blocks and a c notch.. i also have 2 inch spindals for the front..
__________________
66 CHEVY STEPSIDE 2WD W/283 ( FAMILY HAND ME DOWN) 81 CHEVY SHORT BED 2WD W/250 4SPD TRANS STRAIGHT 6 ( CURRENTLY UNDER CONSTRUCTION) 01 SILVERADO SHORT BED 2WD W/4.3 5SPD TRANS ( DAILY DRIVER) Sold 03 SIERRA 4X4 STEP SIDE EXTRA CAB 5.3 AUTO( NEW DD) 09 CHEVY COBALT W2.2 AUTO (GF'S DAILY DRIVER) |
|
|
| Bookmarks |
|
|
Threaded Mode