Engine installation

[zac]

Trying to get the new engine in my K10 burb, picture is after failed attempt #1. I've never actually installed an engine in one of these, and never in a manual trans vehicle. I should have an engine leveller but don't. I think I've got it hooked up right this time for a better angle. Getting the pan over the crossmember and then getting the input shaft into the throwout bearing and disc--painful. I did use a clutch alignment tool. On the first attempt the clutch fork popped the clip on the pivot ball, it is taken care of now. Throwout bearing is very uncooperative. If you guys have any tips or tricks, I would really appreciate it.