|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
07-24-2011, 10:51 AM
|
#1 |
|
Registered User
Join Date: Nov 2010
Location: Fayetteville NC
Posts: 752
|
HELP!!! Disc brake swap going horribly awry!!!
I'm in the middle of my disc brake swap and the bearings I got that are supposed to fit my spindles don't. I was told that the crossmember I purchased came off of a 1973 C10. Here are the shaft diameters and rotor diameters
Wheel bearing Spindle: 1.37" Rotor: 2.52" Oil Seal Spindle: 0.84" Rotor: 2.06" Are these not C10 spindles? I know they're off a square body (look exactly like my buddy's 81) Additionally I have a lot of play between my one tie rod end and the spindle...what is up with that? I tightened the castle nuts just to the point where I could get the cotter pin through the hole.
__________________
1966 C10 Long step build on a budget http://67-72chevytrucks.com/vboard/s...d.php?t=445201 no garage, no shop, limited storage space and tools....no problem. |
|
|
| Bookmarks |
|
|
Threaded Mode