A little help please... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

r&r419 · 08-10-2011, 09:21 AM

Hey guys,

I just bought a 1972 SWB yesterday, and it has a freshly rebuilt 1996 Vortec 5.0 crate engine, with a brand new crate 4L60E in it. It has the original wiring harness, and ecm. Here is the problem.... I don't know much about the wiring of the newer vehicles, and this could pose a problem for me. Do you know of a good wiring harness to match up to the existing one?? Because I would like to run the fuel injection and electronic tranny, but if it's going to cost $1500 for a harness, or take an expert to install it, I will just put an intake, carb, and a 700R4 in it. Can I please get some suggestions and or comments?? Thanks guys.

08-10-2011, 09:21 AM	#1
r&r419 Registered User Join Date: Aug 2011 Location: Mabank Tx Posts: 22	A little help please... Hey guys, I just bought a 1972 SWB yesterday, and it has a freshly rebuilt 1996 Vortec 5.0 crate engine, with a brand new crate 4L60E in it. It has the original wiring harness, and ecm. Here is the problem.... I don't know much about the wiring of the newer vehicles, and this could pose a problem for me. Do you know of a good wiring harness to match up to the existing one?? Because I would like to run the fuel injection and electronic tranny, but if it's going to cost $1500 for a harness, or take an expert to install it, I will just put an intake, carb, and a 700R4 in it. Can I please get some suggestions and or comments?? Thanks guys.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.