![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#3 |
Registered User
Join Date: Aug 2011
Location: Wichita, KS
Posts: 318
|
Re: LMC Rollpan for my 85 Fleetside
Ya, it's the steel one. I measured the opening on my truck versus the width of the pan. the pan is 1/2 an inch too wide. Even if I were to cut it down, the licence plate area bubbles out too much for it to sit flush.
I'm gonna return it and get a chrome bumper for it instead. Not the clean look I was wanting. EDIT> For the curious, the opening on the back of my truck is 67 inches wide while the pan is 67.5 inches wide. Might have it up if it wasn't for that 1/2 inch. I might keep it and have a body shop put it on for me. I need to get the rear fender wells patched anyways.
__________________
Project and Truck Specs: http://67-72chevytrucks.com/vboard/s...d.php?t=483381 Last edited by jdheff1982; 08-31-2011 at 03:36 PM. |
![]() |
![]() |
Bookmarks |
|
|