Engine and Trans mount question and opinions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

hotrod1 · 09-16-2011, 11:18 AM

Opinions please.

There are a few ways to mount an engine and trans. Using the stock insulator (either rubber or urethane) and then create a mount to the frame from there. The other is to mount directly to the block and create a mount to the frame that uses urethane isolators (see pics).

The same can be done for the transmission. Hard mount the cross member directly to the transmission (with no rubber or urethane mount) and then put isolators where it bolts up to the frame.

What opinions do you have?

09-16-2011, 11:18 AM	#1
hotrod1 56 - autocross Join Date: Apr 2010 Location: Camarillo, Ca Posts: 1,121	Engine and Trans mount question and opinions Opinions please. There are a few ways to mount an engine and trans. Using the stock insulator (either rubber or urethane) and then create a mount to the frame from there. The other is to mount directly to the block and create a mount to the frame that uses urethane isolators (see pics). The same can be done for the transmission. Hard mount the cross member directly to the transmission (with no rubber or urethane mount) and then put isolators where it bolts up to the frame. What opinions do you have? Attached Images



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.