Progess Report

[72ArizonaBurb]

I don't have pictures at this time of the mounting backets. I have the rear of the seat sitting up on top of the ledge then I had 2 pieces of 4" square tube cut to make the spacers for the outer support and 2 pieces of 3" square tubing cut for the inner support. I had the welding shop drill 1/2" holes in the center of each for the mounting bolt to slide through. By mounting on top of the shelf it allowed me to set the seat back as far as I wanted and create leg room for the passengers. I also painted the brackets to match the exterior of the truck. I will post some pics once I get them installed.