How low? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Racer Pops · 11-22-2011, 06:35 PM

I have a '56 project that I am working on that has the TCI IFS frontend and TCI springs in the rear. I just installed my new tires/wheels and the rear of the truck sits about 2" higher than I want it to. I already have a 55 that I drive and I like the way it sits. The frame has been c-notched and I am trying to avoid doing that on this project unless I just have to. My question is this: how much clearance is recommended between the rearend housing and the chassis so that it won't bump while driving? I have right at 4" now and would like to drop it another inch or two. It would be nice if I can just install 2" blocks and be done with it, but I DO have the equipment to do the notching. Was hoping to not have to have big tubs in the bed.

All suggestions appreciated.

11-22-2011, 06:35 PM	#1
Racer Pops Registered User Join Date: Nov 2011 Location: Marion, (San Antonio), TX Posts: 4	How low? I have a '56 project that I am working on that has the TCI IFS frontend and TCI springs in the rear. I just installed my new tires/wheels and the rear of the truck sits about 2" higher than I want it to. I already have a 55 that I drive and I like the way it sits. The frame has been c-notched and I am trying to avoid doing that on this project unless I just have to. My question is this: how much clearance is recommended between the rearend housing and the chassis so that it won't bump while driving? I have right at 4" now and would like to drop it another inch or two. It would be nice if I can just install 2" blocks and be done with it, but I DO have the equipment to do the notching. Was hoping to not have to have big tubs in the bed. All suggestions appreciated.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.