My Build: Home Depot Machine

[baggedbigblock]

My first attempt at bondo work. The deepest area is the thickness of the sheet metal. I ground down all the welds until flush and then filled with bondo. I built up more so I could sand it down, but damn it is tough to sand. I am going to do some more research on body work and try to save myself time and energy. I also test fit the new alternator, the other one didnt fit. I will paint this one once all the fab work is done. I also finished the rear fuel cell support, redid the rear axle and painted the rear back setup. Still more X bracing to do in the rear for shock mounts and the 2" rear blocks are still being mailed. I also test fit my gilmer drive setup and my new headers, and amazingly I can fit the steering rack in there!!!











needs a shorter belt