Dropping the 1 ton!

[tc4x4]

Axle flip kit, should give me 5 inches lowered for the rear end.

http://www.gcustoms.com/7387-chevygm...4c1cf11a77ea63

2 inch drop springs for the front, cut out one coil should get me another 2 inch drop and trim the bump stop, should get me 4.5 inch drop.

http://lmctruck.com/icatalog/cc/full.aspx?Page=141

Does this sound like im on the right track. I'm pretty much doing it just like Charlsdur did.

http://67-72chevytrucks.com/vboard/s...d.php?t=286975



Couldn't i just cut a couple coils out of my stock coil springs up front and wouldn't that lower it about 4 inches? Instead of buying half ton springs?

Where can i buy some after market upper and lower control arms for my truck, that would work with my plans here? I like the clean look of the after market tube control arms.