The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-26-2012, 09:43 PM   #1
Rubble
Registered User
 
Join Date: Feb 2012
Location: Big Valley. Alberta
Posts: 674
Rear spring hangers

I am in the process of converting a 1987 1 ton 4x4 dually to a single rear wheel.This truck had Dana 60 in front & 70 rear. Axle ratio was 4:56. This truck has a 6.2 with TH400,I didn't need that heavy of a diff and wanted a higher speed axle as this truck won't be used to tow anything.When I went to mount the semi float 14 bolt in rear I found spring perches about 1" too wide on either side. I measured the hangers on my 86 3/4 ton 4x4 and they are about 1" wider. I took a set of hangers off a parts truck so axle will fit ok now. Just wondering if this is common?This truck was seen lots of changes before I got it so anything is possible.thanx
Posted via Mobile Device
Posted via Mobile Device
__________________
1977 Chev C30 454/465/14ff DRW
1974 Chev C20.350/465/14ff

" Rock n Roll ain't noise pollution"
Rubble is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:25 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com