|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-16-2003, 02:30 PM
|
#1 |
|
Registered User
Join Date: Nov 2001
Location: Springfield, MO
Posts: 2,943
|
6 cylinder engine stand question?
Guys I know this is covered over and over. Talking about placing the V8 in the 6 cyl position. I guess this is done using the 6 cyl mounts? Does this lower the engine also? I have not seen any of the mounts. I am thinking about this as a possiblity I am in need of getting the drive shaft cut anyway and wondering if those mounts are what I need? If so how much should they be and does anybody have a good set to spare? I am eventually going to be at the stage where I can try the different settings and move them if I dont like it before I bolt everything down.
Thanks Dave
__________________
Dave 1968 Custom Chevy with turbo charged 5.3 gen III 4l80e swap 1967-71 GMC 3/4 ton long step 4x4 (not sure what year exactly?) "A good friend will bail you out of jail...but a true friend will be sitting next to you saying "that was frekin awesome". "If it doesn't fit force it...If it breaks then it needed to be replaced anyway!" |
|
|
| Bookmarks |
|
|
Threaded Mode