Rear Cab Crossmember - The 1947 - Present Chevrolet & GMC Truck Message Board Network

LSUMurse · 04-03-2012, 05:31 AM

I have a '68 Stepside LWB with a rusted out rear cab crossmember. It's only rusted out on the extreme ends of each side with some rust going through the floor. I don't have access to a garage, so pulling the cab off is going to be just about impossible for me. Can the crossmember be changed without pulling the cab off? -OR- Has anyone ever used the crossmember covers for the ends?

Brothers has them:

http://www.brotherstrucks.com/prodin...number=RFS72C0

I tried looking through past threads and the FAQ, but couldn't find anything about this specific question. Any help or advice would be greatly appreciated.

04-03-2012, 05:31 AM	#1
LSUMurse Registered User Join Date: Mar 2012 Location: New Orleans, La Posts: 406	Rear Cab Crossmember I have a '68 Stepside LWB with a rusted out rear cab crossmember. It's only rusted out on the extreme ends of each side with some rust going through the floor. I don't have access to a garage, so pulling the cab off is going to be just about impossible for me. Can the crossmember be changed without pulling the cab off? -OR- Has anyone ever used the crossmember covers for the ends? Brothers has them: http://www.brotherstrucks.com/prodin...number=RFS72C0 I tried looking through past threads and the FAQ, but couldn't find anything about this specific question. Any help or advice would be greatly appreciated.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.