|
04-21-2012, 09:04 PM
|
#7 |
|
Registered User
Join Date: Aug 2009
Location: Bowser
Posts: 13,786
|
Re: HEI Installation
No ballast resistor. A resistance wire comes from the ignition and is spliced together with the yellow wire to the coil and another yellow wire to the starter solenoid. You need to replace the resistance wire with a 10 gauge wire and disconnect the yellow wire at the solenoid.
You can you use the existing spot the resistance wire plugs in to the power block on the firewall or run your 10 gauge wire to an unfused 12 volt connector on your fuse block. |
|
|
| Bookmarks |
|
|
Threaded Mode