|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-23-2012, 03:34 AM
|
#1 |
|
Registered User
Join Date: Dec 2011
Location: Belgium
Posts: 82
|
U joint doesn't fit in the yoke anymore ...
I took apart my drive shaft to clean and paint, and now when I'm assembling it again, I can't get the U joint in the yoke anymore ...
When I measure the width of the u joint, it's 1,5mm (a bit less then 1/16") wider then the room between the 2 holding clips of the yoke ... I marked every part when I removed it, to be sure everything goes back the way it was ... Any suggestions on how to get it back in ? |
|
|
| Bookmarks |
|
|
Threaded Mode