front end body alignment

[Gregsenne]

Anyone have any tips on getting the core support aligned properly (especially without removing the front clip again!!!)? I just threw my core support on and the rest of my front end (without thinking about it's positioning), and went to bolt my hood on (last piece of the project), and it doesn't line up. Now looking at it, the whole front clip is about a half inch to the side.

I loosened the two core support-to frame bolts and tried to push the whole front end over (it moves slightly, but just comes right back in the same spot). I'm thinking of putting a comealong on a hole in the core support and yanking it back over. Any thoughts?