Drive Shaft Binding - The 1947 - Present Chevrolet & GMC Truck Message Board Network

SoCal68 · 09-24-2003, 03:41 PM

I have a Blazer witha 350/ T400. The engine was placed in the stock location with a trans crossmember off a 2 wheel drive. Also, the blazer has a 6 in lift. The drive shaft binds when the yoke is set into the rear axle. I had the driveshaft made to the correct length????? Any suggestions, answers, or drive shaft pictures of trucks with 6" lifts would greatly be appreciated.

Also, the distributor seems to be very close to the firewall...is this comon. The engine has HEI.

09-24-2003, 03:41 PM	#1
SoCal68 Registered User Join Date: Jun 2002 Location: Southern California Posts: 22	Drive Shaft Binding I have a Blazer witha 350/ T400. The engine was placed in the stock location with a trans crossmember off a 2 wheel drive. Also, the blazer has a 6 in lift. The drive shaft binds when the yoke is set into the rear axle. I had the driveshaft made to the correct length????? Any suggestions, answers, or drive shaft pictures of trucks with 6" lifts would greatly be appreciated. Also, the distributor seems to be very close to the firewall...is this comon. The engine has HEI.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.