64 Radiator swap

[McCoyAZ]

The original radiator in my 64 is tiny at only about 18 inches wide and 2 inches thick. It was for a straight 6 and I guess it worked on that motor okay.


I swapped the straight 6 out and replaced it with an older 283 and bought a radiator that is supposed to fit in the original mounting location but it doesn't. This new one is about 26 inches wide and 2.75 inches thick.

I was told it would slip right in and be a direct replacement but it wont fit down into the slotted mount and it is wider then the front cross member.

What options do I have to mount this radiator into the truck?

There are no side flanges installed on it so it wont bolt into the radiator support frame.

How did the 64's that came with a V8 mount up?

Thanks in advance