Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
06-28-2012, 09:56 PM | #1 |
Registered User
Join Date: Dec 2008
Location: Andrews, NC
Posts: 194
|
Exhaust Plans/ Will this work?
I'm back from Afghanistan & ready to get my 66 1/2 SWB fleetside back on the road. First up is to replace the rusted out headers & exhaust. I have owned the truck almost 10 years and this is the second set to rust through.
I decided to go to rams horn manifolds & found a set like the picture. The rams horns have a 2" outlet. I don't run my engine @ high rpms very often & I would rather pick up some low end power & mileage improvement. Behind the rams horns, I want to run a stainless kit as shown, I can get the kit in 2 inch, 2.5 or 3 inch. I'll add some stainless flowmasters to match the diameter. Is there any problem or likelyhood that by increasing the diameter, I'll build in a power loss? Thanks for any advice you can provide. Blue 666 |
Bookmarks |
|
|