Porterbuilt Crossmember

[Rusty Wrenches]

Okay so I dont have porterbuilt's beautiful products in my hands yet but in preparation i am going through my truck slowly and and this truck is going to keep its drivetrain for a while which is a 250/ 3spd originally column but not aftermarket floor setup. My issue is after all my research i've never seen anyone complain about the transmission crossmember being lower than the frame, just the crossmember hence the dropmember inception. Whats my options here? I tried to load photos but my mac is being a douche. any help here would be appreciated. I'll change transmissions if i have to but this truck runs great and has no need for it so if there is a way around this I would prefer it!