|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
08-26-2012, 09:17 PM
|
#1 |
|
Registered User
 
Join Date: Jul 2012
Location: St. John, Washington
Posts: 618
|
Drilling fenders for side moldings
I bought a pair of used chevy fenders to put on "rusty", but they came without pre-drilled holes for the side moldings. The emblem holes are there as well as the holes for the "8-350" callout. what is a good way to drill the holes in the correct spot. can it be done with the fenders off of the truck? be nice to get them drilled before i have everything painted.
Sorry if this has been brought up before. I tried searching a few different keywords but i just didnt come up with anything that i felt was useful for me. Thanks
__________________
"Rusty" 1972 K20 Cheyenne Super, 496, A/C, Tilt, Tach, Buckets, 4l80e/NP205, 4" Rancho Lift, 35" BFG AT "Ramp Truck" 1972 C30 Ramp Truck 350, Air Bags, Factory A/C. "1968" C10 Shortbed project |
|
|
| Bookmarks |
|
|
Threaded Mode