67 cheby's Dropmember build thread (CLOUD 9)

[67cheby]

Originally Posted by XxCHEVYMANxX

Hey Mike, have you figured out your column issue? I have a 67, and 68 non tilt columns, and they both have the same wire cover and two small tabs that it slides under. I couldnt find slots like yours anywhere on either column. Hope you already have it sorted out.

nope not yet ?? i dont know , anyone else have any input ?

Originally Posted by Xeen

A couple of questions that could clear up a few things for us.
Is it a 1967 GM Truck Column, 36"L X 3/4" OD shaft?
Is it a genuine GM column or a Reproduction?
Is it tilt or non-tilt?
A little more information would be helpfull.
Im sure there are tons of experts on here that could help you with this, now if we could only get them to chime in.

it is a genuine GM column and it is tilt

Originally Posted by watahyahknow

could it be that the slots are for tabs that are on the original cover itself?
it might be that the cover sticks in on one end and get screwed tight on the other end or that the tabs are hooked and on both sides and you need to push it in untill the tabs fall in the holes and the setup click shut , it would make more sense in a factory setup than using 4 clips to hold it down

I dont know i will look ?